Zero G: Installing the Cassette - Flush Mount - Using the L-Brackets

Disclaimer

Failure to comply with the following steps will result in a void of the manufacturer’s warranty. The dealer/ installer will be responsible for all costs associated with failure to comply, including replacement parts, and/ or additional on-site visits needed for repair work.

Zero G: Overview - Please Review before installation.

---

Opening the Box

• Do not remove the foam(A) or packaging inside the cassette at this time.
• Cut the straps to open the box, then remove the trim pieces, doors assemblies, and mounting brackets and set all of them out of the way of the installation area.
• Tear away the foam from the top of the case but leave the foam inside the case

---

Pre-mounting and Power Consideration

Before mounting the screen, consider how power and data will be routed to the screen. Depending on site conditions, it may be necessary to run these wired or pull a cord before case installation. With the breaker Off, run the power and control cables through their appropriate case penetrations.

• Pass the control and power cables through the appropriate openings in the case.

---

Installation Type - L-Brackets

Step 1:

• Measure full length of the case (F).
• Blocking required. The ceiling or wall used for fixture installation must be able to support 300 lbs or more. Failure to properly secure the screen may result in injury and/or damage.

---

Step 2:

• Cut a hole in the ceiling using the Z and W values from the formula above.

---

Step 3:

• Install the brackets so that they will be 2” - 18” from either sides of the cassette.
• The ideal range is 2” - 4”. Level the brackets to within 1/8” over 10’ using the case length (F); as well as 1/2”over 1’ using the depth (W) of the pocket.
• Failure to properly level the mounting brackets may create issues with the screen over time, which could damage the screen material.

---

Step 4:

• Make sure bracket hook screws (see Fig. A) are backed out all the way down, before putting the screen in place.
• Hook the bracket into the appropriate grooves (see Fig. B) in the case.
• You may need to raise the case by tightening the screw on the back 3 hooks to hook in the front hook. 
• Installation requires three or more people. The product weighs up to 225 lbs. Please use safe lifting and rigging techniques.

---

Step 5:

• Install the door trim test piece into the case to use as a reference for the following Step 6.

---

Step 6:

• Raise the case up until the door test trim piece is flush with the ceiling.
• Repeat this at the front and back of all mounting brackets.
• Level the case to within 1/8” over 10’ using the case length (F); as well as 1/2”over 1’ using the depth (W) of the pocket.

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com