Zero G: Lowering the Drop Height

Disclaimer

Failure to comply with the following steps will result in a void of the manufacturer’s warranty. The dealer/ installer will be responsible for all costs associated with failure to comply, including replacement parts, and/ or additional on-site visits needed for repair work.

Zero G: Overview - Please Review before installation.

---

To Lower the Drop Height (Viewing Area)

Step 1:

• While using Moab in User mode, press the UP button to raise until it is nested in the wing, and tension has been taken off of the wing cable, then press the STOP button.
• Do not exceed the maximum drop of 95-inches or shorter depending on your screen size.

---

Step 2:

• Loosen the thumb screw connected to the wing cable spool.

---

Step 3:

• Turn the knob to allow the pulley to move away from the stopping block. Make sure to unwind more cable than you will need to lower the screen to the desired drop.
• Perform steps 2 and 3 on both ends of the screen. 

---

Step 4:

• Press the DOWN button on the Moab until the top of the viewing area is at the desired viewing height, then hit the STOP button.
• If your screen begins to open on either side before your desired viewing height, go back to Step 2 and release more wing cable.

---

Step 5:

• Turn the knob until the moving pulley is firmly pressed against the stopping plate.

---

Step 6:

• If cable becomes loose make sure the it is still set correctly on all pulleys as shown. 
• Thumb screw must be firmly tightened to prevent the drop setting from changing.

• Make sure the wing cables both have tension on them. Tighten the thumb screw firmly to secure the wing drop setting.

---

You will need to adjust the lower limit to accommodate the new drop height

Click here to Set the Lower Limit

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com