Zero G: Setting the Lower Limit

Disclaimer

Failure to comply with the following steps will result in a void of the manufacturer’s warranty. The dealer/ installer will be responsible for all costs associated with failure to comply, including replacement parts, and/ or additional on-site visits needed for repair work.

Zero G: Overview - Please Review before installation.

---

Step 1:

• Upper limit is pre-set at the Factory, if the upper limit requires adjustment, please contact SI support for further assistance.
• To set the lower limit, make sure the MOAB is in programming mode.
• Hold the DOWN button on the MOAB until the viewing area is fully visible with no more than 3” of backer showing at the bottom then release the DOWN button to stop.
  • To prevent damaging your Zero G, the UP button has been disabled while the MOAB is in programming mode.
  • If you go past your desired lower limit location, simply place the MOAB into User mode, press the up button to go above where you want your limit to be.
  • Put the MOAB back into programming mode, and press the DOWN button to go to your desired lower limit.
• To save the limit, hold the green STOP and blue DOWN buttons until the LEDs flash, then let go.

---

Step 2:

• Put the MOAB into User mode for normal operation

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com