Zero G: Setting the Drop Height

Disclaimer

Failure to comply with the following steps will result in a void of the manufacturer’s warranty. The dealer/ installer will be responsible for all costs associated with failure to comply, including replacement parts, and/ or additional on-site visits needed for repair work.

Zero G: Overview - Please Review before installation.

---

Setting the drop for Viewing Height

Step 1:

• Remove the stickers labeled “REMOVE BEFORE OPERATING” that secure the cables to the helix inside the case, leave the remaining foam in place. It will lower with the screen and be easy to remove later. Ensure dynemma is on helix and all pulleys.

---

Step 2:

• If the cable becomes loose, make sure the it is still set correctly on all pulleys as shown.

---

Step 3:

• While using Moab in User mode, press the DOWN button, and once the screen reaches the desired drop, press the STOP button.

• The top of the viewing area is indicated on the protective tube.
• Remove any packing foam remaining inside the case that did not lower with the screen.

• Max drop is 95”or shorter depending on screen size.
• Must have minimum of a 12" drop from ceiling, or bottom of the cassette.
• The motor is thermally protected. If the motor stops running during setup, let it cool down for at least 30 minutes before attempting to run it again.

---

Perform steps 4 through 6 on both sides of the screen

---

Step 4:

• Loosen the thumb screw

---

Step 5:

• Turn the knob until the moving pulleys are firmly pressed against the stopping plate.

• If the cable becomes loose, make sure the it is still set correctly on all pulleys as shown. Follow the numbers to indicate where the cables are to be routed if they come off of the pulley grooves.

---

Step 6:

• Both the wing cables should have tension on them.
• Tighten the thumb screw firmly to secure the wing drop setting.
• Perform Steps 4 through 6 on both ends of the screen.
• The wing pulleys should not engage with the stopping plate if you need extended drop.
  • Make sure there is even tension on each wing cable. This will help the drop to be set level to the case on the first try.
  • Thumb screw must be firmly tightened to prevent the drop setting from changing.

---

Remove the packaging

Step 1:

• Dispose of all rubber bands, velcro, and foam.

---

Step 2:

• Carefully remove protective tube and foam wrapped around screen inside protective tube making sure to not damage the screen.

---

Step 3:

• Carefully remove rubber ring without damaging the screen material.

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com