Zero G: Controls - IR

Disclaimer

Failure to comply with the following steps will result in a void of the manufacturer’s warranty. The dealer/ installer will be responsible for all costs associated with failure to comply, including replacement parts, and/ or additional on-site visits needed for repair work.

Zero G: Overview - Please Review before installation.

---

Connecting the IR Sensor

• Connect the IR eye assembly to the case with the thumb screw, then plug into the pre-installed FONTUS if not already installed.

---

IR Remote Use

• If the IR remote is held down continuously as the screen is moving there is a chance that the screen can stop in-between limits. If this happens simply send another IR signal in the direction it was going to continue its movement.
• If a control system is using an IR blaster to control this screen, make sure to limit the period where it blasts the signal one second or less.
  

---

IR Hex Codes

• These codes are to be programmed into 3rd party universal control systems

UP:

0000 006c 0000 000c 0006 011b 0006 011b 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 011b 0006 08a4

STOP:

0000 006c 0000 000c 0006 011b 0006 011b 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 011b 0006 011b 0006 08a4

DOWN:

0000 006c 0000 000c 0006 011b 0006 011b 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 011b 0006 00bb 0006 08a4

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com