Zero G: Installing the Case - External Mount

Disclaimer

Failure to comply with the following steps will result in a void of the manufacturer’s warranty. The dealer/ installer will be responsible for all costs associated with failure to comply, including replacement parts, and/ or additional on-site visits needed for repair work.

Zero G: Overview - Please Review before installation.

---

Case Installation

Step 1:

• Set fascia aside and out of the way of the installation location. Leave the foam around the tube inside the case in place. Remove all other foam and packaging materials.
• Measure full length of the case (F).

Blocking required. The ceiling or wall used for fixture installation must be able to support 300 lbs or more. Failure to properly secure the screen may result in injury and/or damage.

---

Step 2:

• Level the brackets to within 1/8” over 10’ using the case length (F).
  • Note that the bracket screws provide 1/8” additional adjustment after they have been mounted.
• Install the brackets so that they will be 3” - 19” away from the edge of the case on both sides.

Failure to properly level the mounting brackets may create issues with the screen over time, which could damage the screen material. 

---

Step 3:

Installation requires three or more people. The product weighs up to 225 lbs. Please use safe lifting and rigging techniques.

• Make sure bracket screws are backed out all the way before putting the screen in place. Hook the bracket into all 3 grooves in the case.

---

Step 4:

• Tighten the screws to lock in place. Then check to make sure the screen is level to within 1/8’’ over 10 ft. You can make up to 1/8’’ adjustment with bracket screws.

---

If you are happy with the viewing area height then your installation is complete. STOP If not, see the following to adjust the drop

---

Attaching the Fascia

Step 1:

• Lift the fascia up onto the case and make sure that the hook at the top engages the slot on the end plate

---

Step 2:

• Lock the fascia in place on each side by tightening the thumb screw at each end of the case.

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com