Solo 3: Indoor 575/675 Flush Mount - Cassette Installation - Both Methods

---

Click here to read the Introduction and Mounting Options for your type of install

---

ASSEMBLY INSTALLATION – METHOD 1 – ASSEMBLED

This method outlines installation of the cassette with the material tube preinstalled inside.

---

ASSEMBLY INSTALLATION – METHOD 2 – DISASSEMBLED (CASSETTE ONLY)

This method outlines installation of the cassette without the material tube preinstalled inside.

Step 1: METHOD 2 - CASSETTE ONLY

• Unscrew the screws from the weight bar clip (red). 

---

Step 2: METHOD 2 - CASSETTE ONLY

• Remove attached screws from the bracket.
• Set the screws aside.
• Remove clips where attached to the cassette. 

---

Step 3: METHOD 2 - CASSETTE ONLY

• Unscrew the weight bar clip from the weight bar, taking care not to bend the material.
• It is recommended to remove the clip fully once the material roll is installed into the cassette after mounting.

---

Step 4: METHOD 2 - CASSETTE ONLY

• Attach the magnetic end cap to the weight bar, keeping the material from bending.
• It is recommended to wait to attached the end caps after the material roll is inserted into the cassette after mounting.

---

Step 5: METHOD 2 - CASSETTE ONLY

• Undo the silver safety screws, then press the latch as shown.

---

Step 6: METHOD 2 - CASSETTE ONLY

• Using the red straps, loop the straps under the material roll, being careful to avoid the material and any obstructions.
• With the help of the straps on both ends, slowly pull out material roll and set it aside on a clean, soft surface. 
• To avoid scratching the screen material, use packaging foam to carefully pick up the material from the floor.

---

Click Here for Installing in Drywall

Click Here for Installing in a Drop Ceiling

---

Step 7: METHOD 2 - REINSTALLING THE MATERIAL TUBE

• Slide the material roll with mounting plates on each end into the cassette.
• Each end will “click” into place as the brackets engage.

---

Step 8: METHOD 2 - REINSTALLING THE MATERIAL TUBE

• Fasten the silver safety screws on the mounting plates to secure the material roll.

---

Step 9: METHOD 2 - FINISHING TOUCHES - FLANGES

• Rotate flanges into the cassette.

---

Step 10: METHOD 2 - FINISHING TOUCHES - FLANGES

• Hook flanges into the cassette.
• Ensure the flanges are secure by inserting the flange clips as shown.

---

Step 11: METHOD 2 - FINISHING TOUCHES - FLANGES

• Place end (short) flanges into the cassette and screw in to secure.

---

Step 12: METHOD 2 - FINISHING TOUCHES - FLANGES

• Set the door into the cassette; the door will hook in by gravity.

---

Click Here for MOAB mounting and Wiring Instructions

MOAB: Connections and Pinouts

MOAB: Controlling via 12v Trigger

MOAB: Controlling via IR

MOAB: Controlling via Contact Closure

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com