KAOS: Installation Instructions - Outside Mount

---

Step 1: END CAP INSTALLATION

• Verify your order to confirm the correct side for the motor before installing the corresponding end cap.
• Refer to the illustrated instructions for proper mounting, whether for a ceiling or wall installation.

---

---

---

Step 2: END CAP INSTALLATION

• Attach an end cap to each end of the housing using the three provided self-tapping screws.

---

Step 3: HOUSING INSTALLATION

• Use a drill with the appropriate bit size to pre-drill holes, considering the type of surface where the unit will be installed.
• Drill holes through the cassette to accommodate the power cord, and use the grommet to protect the cable from damage.

---

Step 4: HOUSING INSTALLATION

• Position the back part of the housing at the desired location.
• The position may vary depending on the desired location of the weight bar when fully open.

---

Step 5: HOUSING INSTALLATION

• Secure housing with the appropriate screws.

---

Step 6: MATERIAL ROLL INSTALLATION

• To make this step easier, use a sawhorse or any object to support the weight bar of the shade while you proceed with the installation.

---

Step 7: MATERIAL ROLL INSTALLATION

• Manage the cable through the rubber grommet. Attach the motor head to the motor bracket and secure it using the provided clip.

---

Step 8: MATERIAL ROLL INSTALLATION

• Insert the Idler into its bracket and secure it with the provided pin.

---

Step 9: MATERIAL ROLL INSTALLATION

• Align the shade material so the Keder hangs over the edge of the outer tube.
• Confirm that the shade is centered, and secure it using the provided screws.

---

Step 10: MATERIAL ROLL INSTALLATION

• Once the tube is secured in place, use the remote control to roll up the shade material.
  • KAOS: Alpha Motor Programming Guide
  • KAOS: Somfy Motor Programming Guide

---

Step 11: TRACK INSTALLATION

• Measuring and Cutting Tracks:
  • Measure the distance from the ground surface to the bottom of the cassette.
  • Based on that measurement, cut the tracks to be 1/4” shorter.
  • Important: Only cut from the bottom section of the track.

---

Step 12: TRACK INSTALLATION

• Carefully slide the wheel system into the tracks at a slight angle.

---

Step 13: TRACK INSTALLATION

• Ensure the wheels are correctly positioned and properly aligned with the track for smooth operation.

---

Step 14: TRACK INSTALLATION

• Secure both tracks using the appropriate screws.
• Place one screw near the top and another near the bottom of each track, then space additional screws every 12 inches along the track.
• Use a rubber mallet to gently snap the track cover into place.

---

Step 15: TRACK INSTALLATION

• Install the track stopper as shown in the illustration to prevent the wheel system from coming off the tracks.

---

Step 16: TRACK INSTALLATION

• To adjust un-level material: Unroll the shade material until the leveling screws at the tube slider are visible.
• Loosen the screws and adjust the slider as needed.

---

Step 17: COVER INSTALLATION

• Install the front housing and secure it using the provided screws.

• Screw down until its flush with the end cap.

---

• NOTE: If the external cover screw holes are inaccessible, use the cover jig to assist in locating the internal cover screw holes.

NOTE: If the cover jig tabs do not fit between the end of the cassette and the wall, break them off. Gently work the plastic tabs back and forth until they detach completely.

---

Depending on the motor you ordered with your shade, refer to the guides below:

KAOS: Alpha Motor Programming Guide

KAOS: Somfy Motor Programming Guide

---

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com