RTS Low Voltage 50 Series: Factory Resetting and Setting Limits

---

Status LED's:

There is a Red LED on the Motor Head.

• OFF - Motor has limits set, but does not necessarily have a remote paired.
• ON - Motor does not have limits set.
• Blinking (2 slow, 1 quick) - Motor detects RTS activity.
• Blinking (2 blinks, 1 second off) - Receiver Locked
• Blinking (3 blinks, 1 second off) - Thermal Protection

---

Factory Resetting the Motor:

This will erase all limits and paired remotes.

• Use the supplied red tool to Press and Hold all 3 buttons on the motor head until the screen/shade jogs 3 times.

---

Pairing:

• Connect the motor to power (Red LED will turn ON)
• Hold the UP and DOWN buttons together until the screen/shade jogs once.

Check Motor Rotation:

• Press the UP button, if the screen/shade moves down (direction is reversed)
• Push and hold the STOP/MY button until the screen/shade jogs once.
• Confirm motor rotation is correct.

---

Setting new Limits:

• Use the UP and DOWN buttons to move the screen to the desired upper limit.
• Hold STOP/MY and DOWN until the screen begins to move down. Press to STOP the screen near the desired lower limit.
• Fine tune the lower limit using the UP and DOWN Buttons.
• Hold the STOP/MY and UP until the screen starts moving up.
• Stop the screen by briefly pressing the STOP/MY button. Save the limits by holding until the STOP/MY button until motor jogs once.

The screen is now in “run” mode. A momentary press of UP or DOWN will move the screen to the upper or lower limit respectively. Use to STOP/MY the screen at any time.

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com