RTS Wirefree / Low Voltage 30 Series: Factory Reset and Setting Limits

---

Factory Resetting the motor will erase all limits and paired remotes.

To Factory Reset the motor:

• Push and hold the Programming button on the motor head until the screen/shade jogs three times.

---

To pair a remote to the motor:

• Push and hold the Programming Button on the motor head until the screen/shade jogs once.
• Briefly tap the Programming Button on the back of the remote, the screen/shade will jog to confirm.
  • If using a multi-channel remote, select the channel first before tapping the Programming Button on the remote

---

Setting new Limits:

• Use the UP and DOWN buttons to move the screen to the desired upper limit.
• Hold STOP/MY and DOWN until the screen begins to move down. Press to STOP the screen near the desired lower limit.
• Fine tune the lower limit using the UP and DOWN Buttons.
• Hold the STOP/MY and UP until the screen starts moving up.
• Stop the screen by briefly pressing the STOP/MY button. Save the limits by holding until the STOP/MY button until motor jogs once.
• Save the remote by briefly pressing the Programming Button on the back of the remote. The screen will jog once.

The screen is now in “run” mode. A momentary press of UP or DOWN will move the screen to the upper or lower limit respectively. Use to STOP/MY the screen at any time.

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com