RTS AC: Factory Resetting and Setting Limits

***IMPORTANT***

Since Somfy RTS motors use the same procedure to Pair and Unpair an RTS

transmitter, you MUST power only one motor at a time when configuring

Somfy channels.

---

To reset the motor and pair it with your remote control:

1. Start with having power applied to the motor.
2. Remove the power for 2 seconds
3. Re-apply power for 10 seconds.
4. Remove the power for 2 seconds.
5. Re-apply power.
   • The shade will begin to move.
6. When it stops moving, press and hold the programming button on the back of the remote until the shade jogs twice (a single Jog is one (1) Up and one (1) Down movement.
   • Do not release the button until the shade jogs twice or you will have to restart the power-cut process.
7. To Pair the RTS remote to the Shade (if using a multi-channel remote, select the needed channel on the remote before programming)
8. Press and hold the UP and DOWN buttons simultaneously until the shade jogs once.

---

To set the limits of the motor and put it into User mode:

1. If the remote control has already been paired to the Motor from the steps above then continue to Step. 2. Otherwise, with your remote, Press and hold the UP and DOWN buttons simultaneously until the shade jogs once.
2. Check that the motor direction is correct (UP moves the shade up and DOWN moves it down). If incorrect, reverse the motor direction by pressing and holding MY/STOP until the shade jogs once.
3. Move the shade to the desired upper limit. Press and release the MY/STOP and DOWN buttons until the shade starts to move down.
4. If it does not start moving on button release, you’ll have to redo this step
5. Once the shade starts to travel down by itself, press MY/STOP when it gets close to the desired lower limit.
6. Move the shade to the desired lower limit and then press and release the MY/STOP and UP buttons until the shade starts to move up.
7. If it does not start moving on button release, you’ll have to redo this step.
8. While the Shade is traveling up, press the MY/STOP button to stop the shade anywhere between the newly created Limits.
9. Press and hold the MY/STOP button until the shade jogs once to complete and exit the Motor Programming.
10. Press and release (not hold) the Programming Button on the back of the remote and the shade will jog one time confirming the Programming completion, this finalizes the programming, commits the Programming to memory and puts the shade into User mode.

---

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com