Fixed Screens: LED Attachment

---

If IP (Zigbee) LED controller was selected, a Phillips Hue Hub is needed to accommodate integration and should be set up before LED’s are powered. If added later, the IP LED controller will need to be forced into pairing mode which would require the screen to be removed from the wall if installed.

---

Step 1: LED Strips

• Connect the LED Controller to the nuts in the frame piece with the screws included.
• Feed the wires through the hole.

---

Step 2: LED Strips

• Plug the lights into the controller plugs.

---

Step 3: LED Strips

• Use caution in the next steps; do not kink or fold the light strip, which will cause damage in the circuit.
• Use the foam strips provided to loosely wrap LEDs around the corners.

---

Step 4: LED Strips

• Press the lights into the channel on the frame. It is necessary to remove the adhesive backer, the LED strips are securely captured in the LED channel.
• LED foam must be used when rounding the corners to protect the circuit. Failure to do so will damage the LED strips. The strip should gently round the corner.

---

Step 5: LED Strips

• Cut the light strips at the copper pad where indicated to the correct length so they just overlap at the middle of the top frame piece.
• DO NOT cut the light strips at any other location.

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com