Fixed Screens - Split Frame Assembly

---

Step 1: FRAME ASSEMBLY

• Ensure the build is clean and free of debris, it is recommended that assembly be done on a clean drop cloth or similar. 
• The frames are labeled but the lower horizontal frame can be identified by the hole allowing for LED cables, this is particularly important if an LED kit was ordered with the screen.

---

Step 2: FRAME ASSEMBLY

• Horizontal frame pieces should be spliced before adding the vertical frames.
• Assemble the horizontal frame pieces by first installing the large splice bar into one of the horizontal halves and loosely add two counter-sunk screws through the front face of the frame.
• Next, slide the thick and thin splice bars into the horizontal frame and join to the second half of each horizontal frame.
• Align the frame halves before fully installing the countersunk screws through the front of the frame.
• From the frame back, align the remaining splice bars to have two set screw on either side of the splice and tighten the set screws.
• Insert the corner brackets as shown in the diagram; both thin and thick corner brackets have the same profile but thinner brackets are used in the edges of the frame and the thicker corner brackets.
• The thinner bracket is used in the channel closest to the outer frame edge.

---

Step 3: FRAME ASSEMBLY

• Align the frame corners to be flush and 90 degrees before loosely tightening one set screw on either side of the corner (on each corner of the frame) the frame must be square before fully tightening frame screws.

---

Step 4: FRAME ASSEMBLY

• Critical Step: Frame squareness is critically important, refer to the diagram and measure the frame diagonals and compare.
• If the distance is not within 1/8”, push from either side of the longer diagonal until each diagonal is measured within 1/8”.

---

Step 5: FRAME ASSEMBLY

• Install the vertical support bar by aligning the channel plates to be roughly centered on the frame, loosely screw the support bar to the channel plates and adjust to square by measuring top and bottom to the same vertical frame before tightening fully.
• The vertical support bar can be installed off center to accommodate a center channel speaker or electrical outlet when using the LED kit.

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com