Fixed Screens - Standard Frame Assembly

---

Step 1: FRAME ASSEMBLY

• Ensure the build is clean and free of debris, it is recommended that assembly be done on a clean drop cloth or similar.
• The frames are labeled but the lower horizontal frame can be identified by the hole allowing for LED cables, this is particularly important if an LED kit was ordered with the screen.

---

Step 2: FRAME ASSEMBLY

• Insert the corner brackets as shown in the diagram, both thin and thick corner brackets have the same profile but as implied, one is thinner than the other.
  • The thinner bracket is used in the channel closest to the outer frame edge.

---

Step 3: FRAME ASSEMBLY

• Align the frame corners to be flush and 90 degrees before loosely tightening one set screw on either side of the corner (on each corner of the frame) the frame must be square before fully tightening frame screws.

---

Step 4: FRAME ASSEMBLY

• Critical Step: Frame squareness is critically importance, refer to the diagram and measure the frame diagonals and compare.
• If the distance is not within 1/8”, push from either side of the longer diagonal until each diagonal is measured within 1/8”.

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com