MOAB: RS485 Keypad Pairing and Programming

Before controlling your screen, make sure your limits are set and the MOAB is in User Mode

Click Here for: MOAB: Pairing, Motor Rotation and Limit Setting

---

Connect the Keypad to the MOAB:

• Plug the RJ45 from the Keypad to the bottom RJ45 of the MOAB
• Make sure the Dip Switch #1 is OFF/User Mode

• Press and Hold the Blue OR Red button until the corresponding LED begins to blink
  • The Red Pairing LED and the Green ACT LED will flash, wait until this finishes blinking before moving to the next step

• Now, push and Hold the Green button until the corresponding LED begins to blink, and the Red 485 Pairing LED and Green ACT LED will begin flashing

 

• • You will now have 10 seconds to perform the next step
• Next, press the Group or Preset number you wish to program, then press the STOP button on the keypad, and the LED's will stop flashing

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com