MOAB: Controlling via IR

Before controlling your screen, make sure your limits are set and the MOAB is in User Mode

Click Here for: MOAB: Pairing, Motor Rotation and Limit Setting

---

• Dip Switch #2 in the ON position allows the IR Receiver to be active

• State-of-the-art built-in infrared sensor
• Internal DSP filtering for PCM to improved accuracy
• Improved immunity against ambient light and FL lighting
• Improved directivity with ultra wide IR reception

• You may also remove the IR Sensor from the PCB board and extended it for placement in the slot under the screen with included extension cable.
  • Locate the slot on the right side just above the Din Rail feature, using a large flathead screw driver, gently pry the bottom away from the top. Unplug the IR cable to remove the IR Receiver from PCB, place your thumb over the IR Receiver and forefinger over the rear connector and gently move the IR Receiver back and forth a few times until it breaks away from the PCB. Now reconnect the IR Receiver with the included extension cable.

---

IR Hex Codes

UP:

0000 006c 0000 000c 0006 011b 0006 011b 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 011b 0006 08a4

STOP:

0000 006c 0000 000c 0006 011b 0006 011b 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 011b 0006 011b 0006 08a4

DOWN: 

0000 006c 0000 000c 0006 011b 0006 011b 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 00bb 0006 011b 0006 00bb 0006 08a4

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com