MOAB: Pairing, Motor Rotation and Limit Setting

---

Important Notes

• Factory Pairing:
  The Moab board should come pre-paired to the motor, with all limits already set.
  • If the 485 Pairing LED (to the left of the RJ45 Motor Port) is OFF, the motor is paired.
  • If the LED is ON, pairing is required.

---

Step 1: Confirm or Pair the Motor

• Ensure all DIP switches are in the ON (up) position.

• If pairing is required, press and hold the Green Button until the Green LED flashes and the 485 Pairing LED turns OFF.

---

Step 2: Motor Rotation

Motor rotation is factory-set. To adjust:

• Hold the UP (Red) and DOWN (Blue) buttons for one second.
• Test rotation by using small movements with the UP (Red) and DOWN (Blue) buttons.
• If the motor rotation LED does not change or both LEDs are off, a reset or repair may be required.

---

Step 3: Setting Limits

• Ensure all DIP switches are in the ON position.

Upper Limit:

• Use the RED/UP and BLUE/DOWN buttons to position the screen at the desired upper limit.
• Press and hold both the RED and GREEN buttons until their LEDs flash. Release to save the upper limit.

Lower Limit:

• Use the RED/UP and BLUE/DOWN buttons to position the screen at the desired lower limit.
• Press and hold both the BLUE and GREEN buttons until their LEDs flash. Release to save the lower limit.

---

Step 4: Switching to User Mode

• Move Dip Switch #1 into the OFF position.

• In User Mode:
  • A single press on RED/UP will move the screen to the upper limit.
  • A single press on BLUE/DOWN will move the screen to the lower limit.

---

For programming into a 3rd party control system, please visit theses links:

MOAB: Controlling via IR

MOAB: Controlling via 12v Trigger

MOAB: Controlling via Contact Closure

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com