MOAB: Controlling via 12v Trigger

Before controlling your screen, make sure your limits are set and the MOAB is in User Mode

Click Here for: MOAB: Pairing, Motor Rotation and Limit Setting

---

• Use a 3.5mm (1/4”) mono TS phone jack to connect to the 3.5mm port on the bottom of the Moab board.
  • The 12v DC trigger is a latched continuous control signal.
  • When a voltage from 7-12v DC is applied on this port, Moab will turn on the active LED and send a 485 command to the motor.  This will move the motor to the lower limit if connected and power applied.
  • When this same voltage is removed from the port, Moab sends a 485 command to the motor. This moves the paired motor to the lower limit if connected and power applied.

---

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com