Somfy Glydea 60 DCT

⚠️ Warning: Screen Innovations only supports programming and Integration with the use of the RS485(SDN) or Zigbee Modules.

Installation

Instructions that must be followed by the drive and home automation professional installing the Glydea Ultra motor.

• Never drop, knock, drill, or submerge the drive.

• Install a separate control point for each drive.

---

Wiring 

• Cables that pass through a metal wall must be protected and isolated using a sheath or sleeve.

• Attach cables to prevent any contact with moving parts.

• Leave the drive power supply cable accessible — it must be possible to replace it easily.

Steps:

1. Switch off the power supply.

2. Connect the drive according to the information in the table below.

Compatible Controls – Wiring of Control 

1. RS485(SDN) Moudul

2. Zigbee Module

3. 2 NO (Normally Open) dry contact switch

---

Installation

Installation of the Rail

1. Mark the position of the brackets.

2. Drill the ceiling or wall at the correct positions.

3. Attach the brackets.

4. Attach the rail to the brackets.

Installation of the Motor 

1. Unlock the motor.

2. ---

   he drive pulley hole.

3. Lock the motor.

---

Commissioning

Setting the End Limits

1. Switch on the power supply.

2. After the first Open or Close command, the motorized product will run at reduced speed to one end, then the other, to set the end stops.

---

Use & Maintenance

This drive is maintenance-free.

Open and Close Buttons

Press Open or Close to fully open or close the product.

Stop Function 

While the product is moving, briefly press Stop — the product stops automatically.

---

DCT Wiring

✅ Important: Requires DCT Setting Tool (Part: 9014599) Not Supplied

Wire	Description	Terminal
1	CCW (Open) NO Dry Contact	4
2	Stop – NO Dry Contact	5
3	Ground Common	6
	CW (Close) NO Dry Contact

Wire 100V to 240V

Wire	Function	Color
1	Neutral	Blue
2	Live	Brown
3	Earth	Yellow / Green

Control Buttons: Open • Stop • Close

Tool: DCT Setting Tool (Part: 9014599) Not Supplied

---

Tips & Recommendations for Installation

Troubleshooting

Observation	Possible Cause	Solution
The motorized product does not operate.	Wiring is incorrect.	Check and reconnect power.
	Control point not compatible.	Check compatibility and replace if necessary.

---

Tips & Recommendations for Use

If the product still does not work, contact a motorization or home automation professional.

Observation	Possible Cause	Solution
The motorized product does not operate.	Motor is in thermal protection mode.	Wait for the motor to cool down.

---

Technical Data

Specification	Value
Power Supply	100V – 240V
Operating Temperature	0°C to +60°C
Protection Rating	IP 30
Safety Level	Class I