TRO.Y 2: Installation Instructions - Power and Bus Lines

---

Introduction

• • TRO.Y2 is an IP Control gateway that allows 3rd party integration with shades and screens via PoE and RS232.
  • TRO.Y2 allows advanced control options for all motor types including 485, RTS and Zigbee via its integration with wireless bridges.
  • Compatible wireless bridges include LinkProZ, Helen, TaHoma Switch and TaHoma.
  • Another feature allows TRO.Y2 to use handheld remotes and keypads to control any shade or screen.
  • New builtin real-time clock, events and scenes allow for expanded control options.

---

Features

• Embedded commissioning software
• 485 programming
• Powered via PoE
• 4 segmented 485 bus line
• Single integration point for third-party automation systems over IP or RS232
• Compatible with SDN 2.0 (485)
• Works with Somfy Synergy™ API
• Advanced Lutron compatibility
• Din Rail mounting capability
• Built-in Real Time Clock
• Create Scenes and Events for any motor type(s)

---

INITIAL CONSIDERATIONS

• This is designed to be installed indoors, Rack or Din Rail mounted.
• If utilizing Janus, it should be in close proximity to the Janus units not exceeding 200' for each port(refer to pg. 9 for more info.).
• TRO.Y 2 has four 485 ports, in order to segment and improve 485 bus.
• When deploying the shades where ever possible its a best practice to divide the shades into 4 segments. This will improve performance and lower latency on commands.

With 32 shades, and 4 Janus units, the preferred method of wiring is 1 Janus per port or 8 shades per port.

---

INSTALLATION - CONNECTIONS

Step 1: Connecting Power

• TRO.Y 2 uses PoE for Power: Connect to PoE switch or included power injector. (PoE 802.3 - compatible with all versions of PoE AT/BT).

• TRO.Y 2 offers the ability to connect up to 4 segments utilizing the 485 ports, using CAT5e/6 cable.
• For the highest level of performance, each segment should not contain more than 64 shades (for a total of 256 shades).
• If you have a system that contains more than 256 shades, we recommend adding an additional TRO.Y.

• The colors above are based on TIA 568B termination.
• The Helen/ serial port data output (WHT/BLUE) is the transmit (TX) from TRO.Y.
• The Helen/serial port data input (GRN) is the receive (RX) from TRO.Y.
• The labels from the Helen port are from EIA561

High speed control port settings:

• BAUD rate - 4800 - 56k
• Control bits - 8
• Parity - None
• Stop bits - 1

---

Step 2: Connecting BUS Devices without Janus

All 4 ports can be used to connect 485 devices, however no Bus power is provided by TRO.Y 2. 

---

Step 3: Connecting BUS Devices without Janus

PoE Connection provides 3rd party IP control, wireless control and connection to other TRO.Y 2s. 

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com