Zero G Pro: Installation Instructions

---

Screen Overview

---

---

• Due to structural reasons, the position of the screen is not the center of the screen, but it is offset 
• 4¼” (105mm) for small cassette screen
• 3⅛” (80mm) for the large cassette screen, to the right.
• This should be taken into account when determining the location of the mounting hole; it is also recommended to keep a distance of 0.4 meters on the side of the screen power cord for future service.

---

SUSPENDED CEILING INSTALLATION METHOD

Step 1: MEASURE AND MARK

• Measure the distance for the four hanging screw holes on the screen (refer to the diagram below)
• Calculate the screen’s installation position and mark the four hole locations for the threaded rods.
• Cut the threaded rods to the required length and secure them in place.

---

Step 2 : LIFT AND ADJUST

• Use lifting equipment to raise the screen to the installation position.
• Adjust the installation bracket horizontally to ensure the threaded rods align with and pass through the bracket holes.

---

Step 3 : FASTEN AND LEVEL

• Fasten the nuts onto the threaded rods.
• Adjust the nut’s height and use a level to ensure the screen is perfectly horizontal.
• Use lifting equipment to raise the screen to the installation position.
• Adjust the installation bracket horizontally to ensure the threaded rods align with and pass through the bracket holes.

---

---

PRECAUTIONS

• The screen fabric is offset to the right from the casing (take this into account when calculating the installation position).
• For closed suspended ceiling installations, reserve about 15 ¾” (400mm) of space on the power supply side for maintenance.
• Pay attention to the orientation of the screen material’s projection surface (refer to the side view) to avoid installing it backward.

---

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com