Step 1: Prewire Terminations
Determine what wiring system have you ordered and do the pre-wire based on what is shown below.
- Before installing the shades, verify whether the shade was ordered as standard roll or reverse roll.
- Though illustrations in this manual show standard roll shades, the installation for reverse roll shades is the same.
Step 2: Spacer Blocks and Leveling Shims
Spacer Blocks - used to clear an obstruction in the fabric path.
- Connect spacer blocks to shade brackets before installation.
- Do not use more than 4 spacer blocks per bracket.
Leveling Shims - used if the window frame is out of level.
- Connect to shade brackets before installation.
- Do not use more than 2 leveling shims per bracket.
Step 3: Mounting the Brackets
- If mounting to a wall, remove the ceiling flange from motor and idler brackets.
- Install wall bracket/end cap assembly with the supplied screws.
- Measure outside of the bracket to the outside of the bracket width and verify it matches the width the shade was ordered.
- Adjust accordingly
- Brackets must be level before the shade is installed.
Step 4: Installing the Roll
- Remove both end caps.
FOR LOW VOLTAGE MOTORS:
- Connect shade and pre-wire, snap connector into spring clip.
- Align and insert the motor side.
Step 5: Installing the Roll
- Secure with the cotter pin.
- Put idler end cap over idler and snap into place.
- There will be an audible "Click"
- Replace and fasten motor end cap.
FOR WIREFREE MOTORS:
- Align and insert the motor side.
- Make sure the motor head bracket is fully seated.
-
Install magnetic connector into end cap and fasten with 0.050” hex tool (included)
- Magnet must be flush with end cap.
- Install end cap and fasten with 0.125” hex tool (incl.).
- Route magnetic connector wire behind cotter pin and away from fabric roll.
- Put idler end cap over idler and snap into place.
For issues, contact Screen Innovations:
Phone: 512.832.6939 Option 3
Website: www.screeninnovations.com
Comments
0 comments
Please sign in to leave a comment.