Nano: Wiring Pinouts

---

24v DC - 485: Using 5 Conductor Wire

---

24v DC - 485 : Using 5 CAT5/6

• Wire between Janus terminal block face and the motor only.

On the Phoenix Connector:

• V+ = BLUE PAIR
• V- = BROWN PAIR
• + = ORANGE WHITE
• - = ORANGE
• G = GREEN PAIR

                       

---

24v DC - 485:  Using 4 - Conductor Wire

• If the pre-wire does not have a third insulated data conductor for the 485 ground, terminate the wire as shown below.
• Use the same termination on both ends. 

---

WIRING - 24v DC - RTS

• For guaranteed motor performance the supplied voltage for 24v motors must be 24v DC.

 

• See the table below for maximum wire lengths.

• If the motors are powered using a Power Distribution Enclosure connect the motors to the “+24v DC” and “-24v DC” ports on the terminal blocks.
• The RS485 ports are unused.

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com