Dan Rosen

Download PDF      

Adjusting The End Limits NOTE: Programming should not be inactive for more than 2 minutes, or the motor will exit programming mode. Feedback from the motor is given by a single “jog” or a series o...

    Introduction Features: Embedded commissioning software 485 programming Powered via PoE Four segmented 485 bus line Integration with third-party automation systems via IP or RS232 Compatible...

By removing the cover during installation, inspection of the roll and screen material are possible. Servicing Notes: Depending on the mounting, removal and reinstallation of the screen may be re...

NOTE: When Programming, all button presses must be completed within 2 seconds of the previous press. This function gives the possibility to deactivate the obstacle detection during the downward mov...

Disclaimer Failure to comply with the following steps will result in a void of the manufacturer’s warranty. The dealer/ installer will be responsible for all costs associated with failure to comply...

TUBE LEVELING To level Solo 3 375 models, note that the idler bearing is positioned on a spring loaded plate that moves up and down. To level this model, set the plate to the appropriate positi...

***IMPORTANT*** Since Somfy RTS motors use the same procedure to Pair and Unpair an RTS transmitter, you MUST power only one motor at a time when configuring Somfy channels. To reset the motor and...