RTS Receiver for 485

---

Somfy's RTS to SDN Module lets you control SDN motors using RTS remote controls.

• Each RTS Receiver can memorize up to five transmitters/channels.
• Each RTS Receiver can store up to five group addresses for SDN.
• Mount the receiver away from any surrounding metal with the antenna pointing up for best reception.

---

1. CONNECT the RTS receiver to a Keypad Port or Master Port on the IGC 4n1 controller. The receiver’s LED will be lit until a transmitter is programmed into memory.
2. INITIAL PROGRAMMING: To program the first transmitter or channel, press and hold the program button on an RTS transmitter (Telis or Decoflex WireFreeTM Keypad) until the LED on the receiver turns off. Release the program button and the LED will light again. Press and release the program button on the same transmitter again and the LED will turn off and remain off. This transmitter is now memorized.
3. PROGRAMMING ADDITIONAL TRANSMITTERS: Press and hold the programming button on the transmitter that is already memorized by the RTS receiver until the LED on the receiver turns on. Press and release the program button on the new transmitter or channel. The LED on the receiver will turn off, indicating this transmitter has been memorized. Repeat this procedure for each transmitter or channel, up to 12 total.
4. DELETING A TRANSMITTER FROM MEMORY: Press and hold the programming button on the transmitter that is already memorized by the RTS receiver, but not the one to be removed from memory. Continue holding the button until the LED on the receiver turns on. Press and release the programming button on the transmitter or channel to be removed from memory. The LED on the receiver will turn off and that transmitter will no longer operate the RTS receiver.
5. MEMORY RESET: Press and release the reset button on the RTS receiver. The LED will turn on indicating that neither transmitters nor channels are memorized. OPERATION: Pressing the UP button on the RTS transmitter will raise or retract the window treatment. Pressing the DOWN button will lower or extend it. Pressing the “my” button when the window treatment is in motion will STOP the window treatment and if the window treatment is stopped, move it to the motor’s 2nd intermediate position.

---

For issues, contact Screen Innovations:
Phone: [phone] Option 3
Website: www.screeninnovations.com